MSI H510TI-S09 - JCI1: Chassis Intrusion Connector; JDMIC1: Digital Microphone Connector

20


This connector allows you to connect the chassis intrusion switch cable.
Normal
(default)
Trigger the chassis
intrusion event

 Connect the  connector to the chassis intrusion switch/ sensor on the
chassis.
 Close the chassis cover.
 Go to .
 Set  to .
 Press F10 to save and exit and then press the  key to select .
 Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.

 Go to .
 Set  to Reset.
 Press to save and exit and then press the  key to select .
1
1 VCC3 2 DMIC_DATA
3 DMIC_CLK 4 Ground

1
1 VCC3 2 DMIC_CLK
3 DMIC_DATA 4 Ground

This connector is used to connect to the digital microphone.
