Hardware Setup
2-19
Power Saving Switch Connector: JGLBTN1
Connect a power saving switch to JGLBTN1. When the switch is pressed, the
system immediately enters into suspend/sleep mode. Press any key and the
system wakes up.
LAN LED Connectors: J2 & J12
The LAN LED connectors are used to connect to optional LAN LEDs, which
show the activity of the LAN. The J2 is for LAN1 port and the J12 is for LAN2
port. Both LAN1 & LAN2 ports are located on the back panel.
J12
JGLBTN1
J2
To Next Page
Loading...
