AWARD
®
BIOS Setup
3-17
each device. The settings are: Auto, Mode 0, Mode 1, Mode 2, Mode 3,
Mode 4.
IDE Primary/Secondary Master/Slave UDMA
Ultra DMA 33/66/100 implementation is possible only if your IDE hard
drive supports it and the operating environment includes a DMA driver
(a third-party IDE bus master driver). If your hard drive and your system
software both support Ultra DMA/33, Ultra DMA/66 and Ultra DMA/100
select Auto to enable BIOS support. The settings are: Auto, Disabled.
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple
sector read/write. If your IDE hard drive supports block mode (most new
drives do), select Enabled for automatic detection of the optimal number
of block read/writes per sector the drive can support. The settings are:
Enabled, Disabled.
Super IO Function Setup
Press <Enter> to enter the sub-menu and the following screen appears:
Power On Function
This controls which part on the PS/2 mouse or keyboard can power on the
system. Settings: Password, Hot KEY, Mouse Left, Mouse Right, Any
Key, BUTTON ONLY and Keyboard 98.
KB Power On Password
If POWER ON Function is set to Password, then you can set a password
in the field for the PS/2 keyboard to power on the system.
To Next Page
Loading...
