BIOS Setup
3-21
OnBoard IDE RAID (Optional)
This setting controls the onboard RAID controller. The field appears only
when your mainboard supports IDE RAID function. Setting options: Disabled,
Enabled.
OnBoard USB 2.0 (Optional)
This item is used to enable or disable the USB 2.0 function. The field appears
only when your board supports USB 2.0. Setting options: Disabled, Enabled.
On-Chip IDE
This setting controls the on-chip IDE controller. Setting options: Disabled,
Primary, Secondary, Both.
Ultra DMA Mode Support
The field allows you to specify which mode the system supports. If installing
a Ultra DMA 133 HDD lead to the instability of the system, then you can set the
HDD to run at Ultra DMA 100 mode by selecting 100 in the field. Setting
options: 100, 133.
Set Super I/O
Press <Enter> to enter the sub-menu and the following screen appears:
Floppy Controller
This is used to enable or disable the onboard Floppy controller.
To Next Page
Loading...
