MSI MS-7036

2-14
MS-7036 M-ATX Mainboard
The mainboard provides connectors to connect to FDD, IDE HDD, case, LAN,
and USB Ports.
Floppy Disk Drive Connector: FDD1
The mainboard provides a standard floppy disk drive connector that supports
360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types.
Connectors
MSI Reminds You...
1. Always consult the vendors for proper CPU cooling fan.
2. CPU_FAN1 CPU_FAN2 supports fan control. Fan/heatsink with 3
or 4 pins are both available.
3. Be sure to configure the CPU FAN PIN Select in BIOS for the
CPU Fan you are using .
4. Please refer to the recommended CPU fans at Intel
®
official
website.
Fan Power Connectors: PWR_FAN1 / CPU_FAN1 /
CPU_FAN2 (optional) / SYS_FAN1 / SYS_FAN2 (optional)
The CPU_FAN1/CPU_FAN2 (processor fan), SYS_FAN1/SYS_FAN2(system
fan) and PWRFAN1 (power fan) support system cooling fan with +12V. It supports
three-pin head connector. When connecting the wire to the connectors, always take
note that the red wire is the positive and should be connected to the +12V, the black
wire is Ground and should be connected to GND. If the mainboard has a System
Hardware Monitor chipset on-board, you must use a specially designed fan with
speed sensor to take advantage of the CPU fan control.
FDD1
Sensor
+12V
GND
PWR_FAN1
SYS_FAN1
Sensor
+12V
GND
CPU_FAN1
Sensor
+12V
GND
CPU_FAN2
(optional)
Sensor
+12V
GND
GPIO
SYS_FAN2
(optional)
Sensor
+12V
GND
GPIO