MSI MS-7036

3-7
BIOS Setup
If you select [Manual], related information is asked to be entered to the following items.
Enter the information directly from the keyboard. This information should be provided in
the documentation from your hard disk vendor or the system manufacturer.
Access Mode The settings are CHS, LBA, Large, Auto.
Capacity The formatted size of the storage device.
Cylinder Number of cylinders.
Head Number of heads.
Precomp Write precompensation.
Landing Zone Cylinder location of the landing zone.
Sector Number of sectors.
Drive A
This item allows you to set the type of floppy drives installed. Setting options: [None],
[360K, 5.25 in.], [1.2M, 5.25 in.], [720K, 3.5 in.], [1.44M, 3.5 in.], [2.88M, 3.5 in.]
Video
The setting controls the type of video adapter used for the primary monitor of the
system. Setting options: [EGA/VGA], [CGA 40], [CGA 80], [MONO].
Halt On
The setting determines whether the system will stop if an error is detected at boot.
Setting options are:
All Errors The system stops when any error is detected.
No Errors The system doesn’t stop for any detected error.
All, But Keyboard The system doesn’t stop for a keyboard error.
All, But Diskette The system doesn’t stop for a disk error.
All, But Disk/Key The system doesn’t stop for either a disk or a keyboard
error.
Base/Extended/Total Memory
The three items show the memory status of your system (read only).