3-16
MS7036 M-ATX Mainboard
On-Chip Primary PCI IDE
The integrated peripheral controller contains an IDE interface with support for
two IDE channels. Choose [Enabled] to activate each channel separately. Settings:
[Enabled], [Disabled].
IDE Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields let you set a PIO mode (0-4) for
each of the four IDE devices that the onboard IDE interface supports. Modes 0
through 4 provide successively increased performance. In [Auto] mode, the
system automatically determines the best mode for each device. Setting options:
[Auto], [Mode 0], [Mode 1], [Mode 2], [Mode 3], [Mode 4].
Primary/Secondary Master/Slave Ultra DMA
Ultra DMA 33/66/100/133 implementation is possible only if your IDE hard drive
supports it and the operating environment includes a DMA driver (Windows ME,
XP or a third-party IDE bus master driver). If your hard drive and your system
software both support Ultra DMA/33, Ultra DMA/66, Ultra DMA/100 and Ultra
DMA/133, select [Auto] to enable BIOS support. Setting options: [Auto], [Disabled].
** On-Chip ATA Setting **
SATA Mode
This setting is used to set SATA mode. Setting options: [IDE], [RAID], [AHCI].
On-Chip Serial ATA
This setting is used to specify the SATA controller. The settings are:
[Disabled]Disable the SATA controller.
[Auto] PATA and SATA will be arranged by BIOS, and you will be
able to see the IDE Device status listed in Standard COMS
Features.
[Combined] PATA and SATA will be combined. Max. of 2 IDE drives in each
channel are available.
[Enhanced] PATA and SATA will both be enabled. Max. of 6 IDE drives are
supported.
[SATA only] Only SATA is operating in legacy mode.
PATA IDE Mode
This item is available for you to select the parallel ATA channel. Setting options:
[Primary], [Secondary].
SATA Port
This allows you to set the boot sequence of serial ATA port.
To Next Page
Loading...
