1-3
Getting Started
On-Board Peripherals
h On-Board Peripherals include:
- 1 floppy port supports 1 FDD with 360K, 720K, 1.2M, 1.44M and 2.88Mbytes
- 2 serial ports, Com1 on Rear IO, Com2 via pin header(IO bracket is optional)
- 1 parallel port supports SPP/EPP/ECP mode
- 1 Line-In / Line-Out / MIC-In / Surround Speaker Out / Center-Subwoofer Speaker
Out / Surround Back Speaker Out
- 8 USB ports (Rear * 4/ Front * 4)
- 1 RJ-45 LAN jack
- 3 * 1394 ports (optional)
On-board LAN (optional)
h Realtek 8100C / 8110S (optional)
- Integrated Fast Ethernet MAC and PHY in one chip
- Supports 10Mb/s, 100Mb/s and 1000Mb/s (1000Mb/s for 8100S only)
- Compliance with PCI 2.2
- Supports ACPI Power Management
Audio
h High Definition link controller integrated in ICH6
h 5.1 channels S/W audio codec Realtek ALC655 codec
1394 (optional)
h Supports up to 3 * 1394 ports, one 6-pin 1394 connector on rear I/O, the other is
supported by onboard pinheader. Transfer rate is up to 400Mbps
h Controlled by Ti TSB43AB23 chipset
BIOS
h 4Mb FWH
h Provides DMI2.0, WfM2.0, WOL, WOR, chassis intrusion, and SMBus for system
management
Mounting and Dimension
h M-ATX Form Factor: 24.5 cm (W) x 24.5 cm (L)
h 6 mounting holes
To Next Page
Loading...
