MS-7380 Mainboard
B-24
During the rebuilding process, the NVRAID Management utility screen shows the
status under the System Tasks and Details sections.
More About Rebuilding Arrays
• Rebuilding Occurs in the Background
The rebuilding process is very slow (it can take up to a day) and occurs in the
background so as not to affect the performance of the system.
• Rebuilding Applies Only to RAID 1/ RAID 0+1 or RAID 5 Arrays
Rebuilding an array works only when using RAID 1 , RAID 0+1, or RAID 5. Rebuilding
does not apply to RAID 0 and JBOD arrays.
• Rebuilding applies to a degraded fault tolerant array
You can rebuild a degraded mirrored array using any available Free Disk or Dedicated
Disk. For example, Figure below shows a mirrored array using two 34.48 GB drives
while having two Free Disks each 55.90 GB large.
To use one of these available free disks to rebuild your array, follow the same steps
as explained in “Rebuilding a RAID Array” on p.B-22, except when prompted to select
a disk, choose one of the two available free disks.
To Next Page
Loading...
