C-11
JMicron RAID
Installing Driver
Install Driver in Windows Vista / XP / 2000
† New Windows Vista / XP / 2000 Installation
The following details the installation of the drivers while installing Windows XP.
1. When you start installing Windows XP and older operating systems, you
may encounter a message stating, “Setup could not determine the type of
one or more mass storage devices installed in your system”. If this is the
case, then you are already in the right place and are ready to supply the
driver. If this is not the case, then press F6 when prompted at the begin-
ning of Windows setup.
2. Press the “S” key to select “Specify Additional Device”.
3. You should be prompted to insert a floppy disk containing the JMicron RAID
driver into the A: drive.
Note: For Windows Vista you can use Floppy, CD/DVD or USB.
4. When prompted, insert the floppy disk or media (Floppy, CD/DVD or USB)
you created in step 3 and press Enter.
5. You should be shown a list of available SCSI Adapters.
6. Select the appropriate JMicron RAID controller and press ENTER.
7. The next screen should confirm that you have selected the JMicron
RAID
controller. Press ENTER again to continue.
8. You have successfully installed the JMicron RAID driver, and Windows
setup should continue.
9. Leave the disk in the floppy drive until the system reboots itself. Windows
setup will need to copy the files from the floppy again after the RAID
volume is formatted, and Windows setup starts copying files.
For Windows Vista:
During the Operating system installation, after selecting the location to
install Vista, please click on the “Load Driver” button to install a third party
SCSI or RAID driver.
Important
Please follow the instruction below to make an “JMicron RAID Driver” for
yourself.
1. Insert the MSI CD into the CD-ROM drive.
2. Click the “Browse CD” on the Setup screen.
3.Copy all the contents in the \\nvidia\IDE\JMicron\JMB363\Floppy32
(for 32-bit OS) or \\nvidia\IDE\JMicron\JMB363\Floppy64 (for 64-bit
OS) to a formatted floppy disk.
4.The driver diskette for JMicron RAID Controller is done.
To Next Page
Loading...
