C-3
JMicron RAID
Be sure to set RAID mode for the JMicron 36x ATA Controller in BIOS before
configuring the JMicron BIOS utility. After that, save the configuration and exit. During
boot up (POST), press CTRL+J to enter the JMicorn BIOS RAID utility.
The RAID Utility menu screen will be displayed. A brief description of each section is
presented below.
Main Menu
Cerate RAID Disk Drive - Create a new legacy RAID set.
Delete RAID Disk Drive - Delete a legacy RAID set.
Revert HDD to Non-RAID - Revert an existed-RAID HDD to non-RAID.
Solve Mirror Conflict - Sovle a mirror conflict.
Rebuild Mirror Drive - Rebuild data, when RAID 1 or RAID 10 data mirroring is lost.
Save And Exit Setup - Save all settings and exit the BIOS utility.
Exit Without Saving - Exit the BIOS utiltiy without any saving.
Hard Disk Driver List
The menu shows the model number and capacities of the drives physically
attached to the SATAII & PATA ports.
RAID Disk Driver List
The menu shows the current configuration of RAID set.
JMicron RAID BIOS Utility
To Next Page
Loading...
