To Next Page

To Previous Page

3-22

BIOS Setup

▍

MS-7596

BIOS Setup

▍

MS-7596

DRAM Tmng Mode

Ths 󰘰eld has the capacty to automatcally detect all of the DRAM tmng.

DRAM Drve Strength

Ths tem allows you to control the memory data bus’ sgnal strength. Increasng the

drve strength of the memory bus can ncrease stablty durng overclockng.

DRAM Advance Control

Ths 󰘰eld has the capacty to automatcally detect the advanced DRAM tmng. If you

set ths 󰘰eld to [DCT 0], [DCT 1] or [Both], some 󰘰elds wll appear and selectable.

1T/2T Memory Tmng

Ths tem controls the SDRAM command rate. Select [1T] makes SDRAM sgnal

controller to run at 1T (T=clock cycles) rate. Selectng [2T] makes SDRAM sgnal

controller run at 2T rate.

DCT Unganged Mode

Ths feature s used to Integrate two 64-bt DCTs nto a 128-bt nterface.

Bank Interleavng

Bank Interleavng s an mportant parameter for mprovng overclockng capablty of

memory. It allows system to access multple banks smultaneously.

Power Down Enable

Ths s a memory power-savng technology. When the system does not access mem

ory over a perod of tme, t wll automatcally reduce the memory power supply.

MemClk Trstate C3/ATLVID

Ths settng allows you to enable/dsable the MemClk Trstatng durng C3 and

ATLVID.

FSB/DRAM Rato

Ths tem allows you to select the rato of FSB/ DRAM.

Adjusted DRAM Frequency (MHz)

It shows the adjusted Memory frequency. Read-only.

Onboard VGA Core Overclock

Ths tem allows you to overclock the onboard VGA.

Onboard VGA Clock

Ths tem wll appear when Onboard VGA Over Clock sets to [Enabled]. It allows you

to adjust the onboard VGA clock.

▶

MSI MS-7596 (v1.x) User Manual

Questions and Answers: