To Next PageTo Next PageWhat causes ozonator failure in mspa F-MO061 Hot Tub?
If the ozonator in your MSpa Hot Tub fails, ensure the water level is above the minimum line by adding more water. If the issue persists, it could be due to damaged internal parts, in which case you should contact the MSpa Service Center. Also, check if the filter pump is working; refer to the "FILTER PUMP DOES NOT WORK“ section.
How to fix no display on the control panel of MSpa Hot Tub?
If there is no display on the control panel of your MSpa Hot Tub, first check the power socket to ensure it's working; change or repair the socket if necessary. Next, check the PRCD (Portable Residual Current Device) and reset it by following the PRCD Testing section. If the controller is still not displayed after pressing the Reset button, or if the PRCD is broken, contact the MSpa Service Center.
General| Model | F-MO061 |
|---|---|
| Type | Inflatable Hot Tub |
| Seating Capacity | 6 |
| Heating System | Rapid Heating System |
| Air Jets | 120 |
| Control System | Digital Control Panel |
| Heater | 1500W |
| Massage Air Blower | Yes |
| Filter Pump | Yes |
| Water Capacity (Liters) | 930 |
| Temperature Range | 68-104°F (20-40°C) |
| Material | PVC |
| Inflation Method | Built-in Air Pump |
Details site requirements for spa installation, including surface, drainage, and clearance.
Instructions for testing the Portable Residual Current Device (PRCD) before each use.
Step-by-step guide for assembling the spa's external control unit.
Instructions on how to inflate the main spa tub wall using the provided pump.
Details on how to operate and adjust the spa's heating system.
Instructions for operating the filtration system and filter cartridge maintenance reminder.
Procedure for draining the spa tub, including using the drain valve and hose.
Table listing LED error codes, their causes, and solutions.
Common causes and solutions for the spa not heating correctly.
