NOTE: It is recommended to fill the spa with lukewarm water for quick heating and energy saving.
NOTE: Ensure the manometer points to the Green section when the spa is filled with water.
NOTE: Always keep the spa cover on to minimize heat loss when heating the water.
WARNING:
Do not drag the spa after filling it with water.
Do not operate the spa until the water reaches the Minimum line.
The water temperature should not be higher than 40°C / 104°F.
Buckle Lock Operation
Heating the water
Place the cover over the spa. Refer to “Controller operation” to turn on the heater.
The hourly heating rate is around 2°C - 2.5°C (2.5°F - 3.5°F) for a 2-person spa or a 4-person square spa, 1.5°C - 2°C (2.5°F - 3.5°F) for a 4-person round
spa, and 1.2°C - 1.8°C (2°F - 3°F) for a 6-person spa.
10
Make sure the filter cartridge remains in place when the spa is
filled with water.
Lock Unlock
CONTROLLER OPERATION
Heater Button
LED Display
Bubble Button
Up Button
Filter Button
Timer Button
Down Button
UVC Button
UP DOWN
HEATER
BUBBLE
FILTER
TIMER
°C
°F
UVC
6 7
To Next Page
Loading...
Need help?
General
