To Next PageTo Next PageWhy is my MSpa Hot Tub in an abnormal shape?
If your MSpa Hot Tub is in an abnormal shape, it could be due to extra air pressure from strong sunlight. Check the air pressure and release air if necessary. During hot weather, it is advisable to check whether some air should be released to avoid any possible damage to the spa pool.
What causes ozonator failure in mspa Rimba?
Ozonator failure in your MSpa hot tub can occur if the water level is below the minimum line; add water above the minimum line. If the issue persists, it could be due to damaged internal parts, in which case you should contact the MSpa Service Center. Also, check if the filter pump is working correctly.
General| Dimensions | Height: 70 cm / 28" |
|---|---|
| Water Capacity | 184 Gal |
| Heating System | 1.2 - 1.8°C/Hour |
| Jets | Air Jets |
| Control System | Digital |
| Heat Increasing Rate | 1.2 - 1.8°C/Hour |
| Power Supply | 220-240V / 50Hz |
| Temperature Range | 20-40°C |
Details site requirements for installing the MSpa, including surface and drainage.
Instructions for testing the PRCD (Portable Residual Current Device) for safety.
Step-by-step guide for setting up the MSpa, including unboxing and inflating.
Details how to operate the heating system, including temperature settings.
Instructions for operating the filtration system and filter cleaning reminders.
Explains how to use the bubble massage function and its settings.
Table listing error codes, their causes, and solutions.
