MTD 2M1 User Manual

Maintenance Schedule
TasksFach Use or
ers.
ery Season

ery Season
or 5s.
ery Season
or 100rs.
Service Dates
Check engine oil
Change engine oil
Check spark plug
Service spark plug
Clean exhaust area
Changing Engine Oil
NOTE: Check the oil level before each use and after every five
hours of operation to be sure the correct oil level is maintained.

Drain fuel from the tank by running the engine until the 1.
fuel tank is empty. Be sure the fuel fill cap is secure.
2.
plug.
Remove the oil drain plug, Figure 7-1.3.
Tip the engine to drain oil into the container. Used oil must 4.
be disposed of at a proper collection center.
Reinstall the drain plug and tighten it securely. 5.


Refill with the recommended oil and check the oil level, 6.
refer to Assembly & Set-Up Section for instructions.
Reinstall the oil filler cap/dipstick securely.7.
Thoroughly wash your hands with soap
and water as soon as possible after handling
used oil.

friendly to the environment. Take it to a recycling center or other
collection center.
To prevent accidental start-up, shut off
the engine and remove the ignition key before
performing any type of engine maintenance.

high level performance is to be maintained. Regular maintenance
will also ensure a long service life. The required service intervals
and the type of maintenance to be performed are described
in the table below. Follow the hourly or calendar intervals,
whichever occur first. More frequent service is required when
operating in adverse conditions.
Engine Maintenance
7


MTD 2M1 Specifications

General

Brand	MTD
Model	2M1
Category	Snow Blower
Language	English