Replacing Belt
Remove the belt cover by removing the five hex screws 1.
that secure it to the frame. See Fig. 7-1.
Remove the belt by grasping it from the bottom of the 2.
auger pulley and pulling outward.
NOTE:
from under the belt keeper. See Fig. 7-1.
To replace the belt follow these instructions and refer to Fig. 7-2:
1.
2.
belt keeper.
Route the belt around the engine pulley.3.
4.
Reinstall the belt cover removed earlier.5.
1
4
3
Service
8
18
To Next Page
Loading...
