MTD 600 Series Service Manual (English)

Other manuals for MTD 600 Series

Service Manual13 pages

Shop Manual150 pages

Illustrated Parts Manual68 pages

Operator's Manual44 pages

Questions and Answers:

T
tlongSep 3, 2025
What to do if MTD Snow Blower engine running erratically?
- M
  Michael PhamSep 3, 2025
  If your MTD Snow Blower engine is running erratically, it might be due to the engine running on CHOKE, stale fuel, water or dirt in the fuel system, a carburetor out of adjustment, or the engine being over-governed. Try moving the choke lever to the RUN position, fill the tank with clean, fresh fuel, or drain the fuel tank and refill it with fresh fuel. For carburetor or over-governed issues, contact an authorized Service Center.
P
phillipsericSep 4, 2025
What to do if MTD 600 unit fails to discharge snow?
- I
  icampbellSep 4, 2025
  If your MTD Snow Blower fails to discharge snow, the chute assembly could be clogged, a foreign object might be lodged in the auger, the auger control cable may need adjustment, the auger belt might be loose or damaged or the shear pins may be sheared. To address this, stop the engine immediately, disconnect the spark plug wire, and clean the chute assembly and inside of the auger housing with a clean-out tool. Also remove any foreign objects from the auger. For cable and belt issues, refer to the corresponding sections, and replace any sheared pins.
J
jeremiah03Sep 5, 2025
Why MTD Snow Blower unit plows snow instead of blowing it?
- J
  Jerry ToddSep 5, 2025
  Your MTD Snow Blower might be plowing snow instead of blowing it due to low ground speed in wet or slushy snow, or sheared shear pins. Increase the ground speed and always operate the snow thrower engine at FULL throttle. Also, replace any sheared shear pins.

MTD 600 Series Specifications

General

Auger Material	Steel
Skid Shoes	Adjustable
Type	Two-Stage
Clearing Width	26 inches
Stages	Two-Stage
Engine Displacement	208 cc
Intake Height	21 inches
Throw Distance	Up to 40 ft