Exhaust
93
6. Remove the four screws that secure the outer heat
shield to the muffler.
See Figure 8.6.
7. Slide the outer heat shield off of the muffler.
NOTE: The inner heat shield is serviced with the muffler.
8. Install the muffler by following the previous steps in
reverse order.
NOTE: Install a new gaskets between the muffler and the
manifold pipe also between the manifold pipe and
the cylinder head.
NOTE: Tighten the muffler and the manifold nuts to a
torque of 13 - 16 ft-lbs (18 - 22 Nm).
9. Test run the engine before returning to service.
Figure 8.6
Outer heat shield
To Next Page
Loading...
Need help?
General
