MTD GCS 50/45 - STARTING AND STOPPING; STARTING WITH THE ENGINE COLD

45
1) Rest the chainsaw on a stable surface.
2) Lift the “STOP” switch lever (fig. 26 part 1).
3) Pull the air knob fully out (fig. 27 part 1). Press
the fuel bulb (Primer) fully down repeatedly (fig.
27 part 2).
4) Hold the chainsaw fast as shown in fig.28.
– Make sure the area around the bar and the chain
is free of any objects.
5) Give the starter cord handle a strong pull, until
the first coughs from the engine (normally not
more than 4/5 times) fig.28.
ATTENTION to the possibility of the
chain moving.
GB
CHAIN SAW OPERATING MANUAL
Do NOT start the chainsaw hold-
ing it with the hand alone
Fig.28
Fig.26
1
STOP
Fig.27
1
1
2
3
2
ENGLISH