Maintenance& Adjustments
6
MaintenanceSchedule
Before
Eachuse
,/
Every
lOHours
Every
25 Hours
Every
50 Hours
Every
I00 Hours
Prior
toStoring
CheckEngineintakeScreen/Cover
CleanHood/DashLouvers _
CheckEngineOilLevel M/ M/
CheckAirFilterfor Dirty,LooseorDamagedParts M/
CleanandRe-oHAir Filter'sFoamPredeaner M/
ReplaceAir Filter Element VII
ChangeEngineOiland ReplaceOilFilter VII
CleanBattery Terminals _
LubeFrontPivotAxleandCasterAxles M/ M/
CleanEngineCoolingFins M/ M/
LubeFrontDeckWheels M/ M/
CheckSparkPlugCondition&Gap M/ M/
ReplaceFuelFilter _"
Maintenance
Engine
WARNING! Before performing any maintenance or
repairs, disengage the PTO, move the drive control
levers fully outward in the neutral position, engage
the parking brake, stop the engine and remove the
key to prevent unintended starting.
Refer to the Kohler Owner's Manual for all engine maintenance
intervals, procedures, specifications and instructions,
Changingthe Engine0ii
WARNING ! If the engine has been recently run, the
engine, muffler and surrounding metal surfaces will
be hot and can cause burns to the skin. Exercise
-- caution to avoid burns.
To complete an oil change, proceed as follows:
1. Run the engine for a short time to warm the engine oil. The
oil will flow more freely and carry away more impurities.
Use care to avoid burns from hot oil.
2. Locate the oil drain hose or the oil-drain valve on the
engine.
NOTE:The 42" RZT's is equipped with an oil-drain valve on the
right side of the engine. The 50" RZT is equipped with an oil drain
hose and is located on the left side of the engine.
To Next Page
Loading...
Need help?
General
