14 Se c t i o N 6— Ma i N t e N a N c e & ad j u S t M e N t S
Lubrication
1. Lubricate pivot points on the auger control and drive
control with a light engine oil once a season, see Fig. 6-2.
2. Lubricate the auger idler bracket with a light engine oil
once a season. See Fig. 6-2.
Auger Shaft
At least once a season, remove the shear pins from the auger
shaft. Spray lubricant inside the shaft and around the spacers and
the flange bearings found at either end of the shaft.
See Fig. 6-3.
Wheels
At least once a season, remove both wheels. Clean and coat the
axles with a multipurpose automotive grease before reinstalling
wheels.
Off-Season Storage
If the snow thrower will not be used for 30 days or longer, follow
the storage instructions below.
Lubricate the machine as instructed earlier in this section.•
Store in a clean, dry area.•
If storing the snow thrower in an unventilated area, •
rustproof the machine using a light oil or silicone to coat
the snow thrower.
Clean the exterior of the engine and the snow thrower.•
NOTE: Refer to the Engine Operator’s Manual for information on
storing your engine.
Figure 6-2
Figure 6-3
To Next Page
Loading...
