1. Switch the mower of
2. Wear protective gloves
3. Turn the mower upside-down.
4. Use another screwdriver to hold the blade when
replacing the blades.
5. Use a Phillip screwdriver to remove the cutting
blade.
6. Place blade over raised screw-hole.
7. Use a Phillips screwdriver to secure the cutting
blade to the blade. The cutting blade must rotate
freely.
8. Repeat the same procedure for the other cutting
blades.
Re-orientate the blade (turn it around or turn it
upside down) as each corner wears out until all
four quarters of the blade have been used. If all
four quarters have been used, then replace blade.
Carry the mower by the handle between the two
rear wheels with the blades pointing outwards.
To Next Page
Loading...
