momentary or toggle. Please refer to your DCC control station manufacturer's
manual for more information on how they handle F Function buttons.
Your MTH PS3.0E+-equipped engine's default short address is 3. So all you have
to do is power up your DCC system and call up Locomotive 3 to begin.
Start-Up/Shut-Down
F3 – Start-Up/Shut-Down
Pressing this twice (toggle on then off) will start up your engine. When you apply
DCC power your MTH PS3.0E+-equipped engine will remain dark and quiet.
Since you likely don't want to run the engine this way, simply press F3 twice to start
your engine. The lights, sound and smoke (if equipped) will come on.
Note – You are actually able to move the engine in DCC without starting it up. Just
increasing the throttle will cause the engine to move. In order for F3 to function correctly
the engine must NOT be moving
To shut your engine down, press the F3 button twice. This will play the shut down sounds
and then turn the lights and smoke and sounds off. As long as there is DCC power still on
the track the engine can be started up again by pressing the F3 button twice.
Bell/Whistle (Horn)
F1 – Bell
To activate the Bell press F1. To deactivate it, hit F1 again
F2 – Whistle (Horn)
To activate the Whistle/Horn, press F2. To shut it off either let off the F2 button
or press and release it
PFA
F4 – PFA
PFA in MTH lingo stands for Passenger/Freight Announcements. Your engine is
pre-programmed for the appropriate type of sounds based upon the type of
service the real-life engine used in daily operation.
There are five sound sequences or segments in the PFA feature. Each segment is
advanced by you, the operator.
You hit the F4 button twice on the DCC controller to let the engine know you
want it to advance (this toggles the PFA
function on then off to clear the remote for the next sequence). In most PFA
sequences there is a minimum wait time of about 20-30 seconds before it will
advance. So, here is how a typical PFA sequence operates:
1. Press the F4 button twice (toggle F4 on then off) to start the PFA sequence on
the engine. You'll hear “Now arriving…” for passenger sound sets and cab
chatter for freight sound sets. The bell will then begin ringing.
2. Slowly reduce the throttle until the train stops at the desired location and speed
reaches zero. Press the F4 button twice (toggle F4 on then off) again and the
bell
M.T.H. HO ES44AC PS3E+ Diesel Engine
16
To Next Page
Loading...