will stop ringing. You will hear the engine sounds switch from the cab to the
station or yard with all the ambient sounds you'd hear in the real thing.
3. Press the F4 button twice (toggle F4 on then off) again to advance the sequence.
You'll hear “Now boarding…” for passenger sound sets and freight yard sounds
for freight sound sets.
4. Press the F4 button twice (toggle F4 on then off) again to advance the sequence.
You'll hear “Now departing…” for passenger sound sets and more freight yard
sounds for freight sound sets.
5. Press the F4 button twice (toggle F4 on then off) the last time to advance the
sequence. You'll hear “All aboard…” for passenger sound sets and more freight
yard sounds for freight sound sets. The engine sounds will switch over to the cab
again. When the bell begins to ring, advance the throttle to move the engine out
of the station or yard. The bell will shut off automatically.
Lights
F5 – Lights
This toggles all your lights (except the headlight) on and off
Master Volume
F6 – Master Volume
There are 10 volume levels. Pressing F6 twice (toggling on then off) raises the
th
Master Volume one level. The Master Volume loops. That is, if you go past the 10
st
level it will loop back around to the 1 or lowest volume level.
Forward/Reverse Signal
Just like a real engine, you can announce the direction of travel using your DCC
handheld and F9 and F10.
F9 – Forward Signal
Pressing F9 twice (toggling on then off) will sound the Forward Signal. This is two
whistle/horn blasts
F10 – Reverse Signal
Pressing F10 twice (toggling on then off) will sound the Reverse Signal. This is three
whistle/horn blasts
Crossing Signal
Again, just like a real engine, you can trigger the Crossing Signal on your engine.
This is two long, one short, one long whistle/horn blast.
F11 – Crossing Signal
Pressing F11 twice (toggling on then off) will sound your Crossing Signal.
M.T.H. HO ES44AC PS3E+ Diesel Engine
17
To Next Page
Loading...