QUICK START GUIDE
Of course, you should read your manual over before running your engine.
But if you just can’t wait, choose how you want to run below and enjoy!
Now, after a few minutes, shut her down and read through your engineer’s
guide.
CAUTION: M.T.H. PS3E+ HO engines OPERATE ON AC VOLTAGE
and are designed to operate on HO 3-Rail Stud-rail track.
I USE AN AC SUPPLY…
Step 1: Unpack your Engine. (refer to unpacking instruction on pg 4)
Step 2: Set the engine on the track
Step 3: Apply increasing AC voltage until she starts up and pulls out!
I USE A REGULAR DC SUPPLY…
Step 1: Unpack your Engine. (refer to unpacking instruction on pg 4)
Step 2: Set the engine on the track
Step 3: Apply increasing DC voltage until she starts up and pulls out!
I'M A DCC/MOTOROLA OPERATOR…
Step 1: Unpack your Engine. (refer to unpacking instructions on pg 4)
Step 2: Set the engine on the track
Step 3: Power up your DCC system
Step 4: Select engine address 3 and press “F3” to start her up
Step 5: Turn the throttle and head on down the pike
I RUN DCS…
Step 1: Unpack your Engine. (refer to unpacking instructions on pg 4)
Step 2: Set the engine on the track
Step 3: Power up your DCS system
Step 4: Add the engine to your system and start her up
Step 5: Turn the throttle and move out
* Please note, when making setting changes in DCS or DCC, such as address, please
wait a minimum of 5 seconds after removing power to insure the settings are stored
in the engines memory. Reapplying power in less than 5 seconds may result in losing
the setting changes.
M.T.H. HO ES44AC PS3E+ Diesel Engine
3
To Next Page
Loading...