Start-up Solution
When I apply power to the
track my engine doesn’t do
anything. No lights, no
sound, no nothing.
Did you press F3 yet? F3 on your DCC
handheld will start your engine up.
Check to see if that section of track has
power. Use a voltmeter or a lit passenger
car, not your tongue.
Slide the engine a couple of feet in either
direction, you may have a bad track
section
Have you got that section electrically
isolated with a toggle switch or other
device?
Sound Solution
I have no sound on my
engine, but my lights are
on and it moves just fine
You may have it turned off. Repeatedly
press F7 to cycle through the volume
levels (there are 9 levels, 0-max)
When I run Doppler I can
hear the Doppler shift but
then the engine sounds
fade out and I can’t get
them back
This is normal. You will need to press the
F12 button again to turn Doppler off.
Your engine sounds will now return to
normal
To Next Page
Loading...