Installation
52 MTS Landmark™ Tabletop Load Units - Product Information
accurate pressure gage.
Each airmount's inflated height—measured from the floor to the bottom of the load
unit’s leg—should be 57–63 mm (2.25–2.5 in).
The load unit can be moved on its pallet with a fork lift, or with its lifting hoist rings (actuator
integral to the base), or with slings (actuator integral to the crosshead) using an overhead
lifting device. Lift the load unit only as high as necessary.
Item Description
1 Hoist Rings
2 Slings
Lift Point Locations
To Next Page
Loading...
