Replacing easy-change fuel filter
with the engine running
1. Cut out the filter to be replaced.
2. Open the threaded vent plugs at the filter
head of the cut-out filter and make sure
that the fuel filter is not pressurized.
Note: New version has two threaded vent plugs,
old version has four threaded vent plugs.
3. Close threaded vent plugs.
4. Remove cut-out easy-change filter using
the oil filter wrench.
5. Clean sealing surface on filter head.
6. Check sealing ring of the new easy-change
filter and coat it with fuel.
7. Fit SOLAS shield (→ Page 73).
8. Screw on easy-change filter and tighten by
hand.
9. Set three-way cock to operating position
(both filters cut in).
10. Replace further fuel filters in the same way.
M015650/05E 2014-03 | Task Description | 97
TIM-ID: 0000004914 - 005
To Next Page