11. Remove sealing rings (1) and (2) of injec-
tor (3) with a self-made hook.
12. After removal, seal all openings with suitable
covers.
13. Remove sealing cap from cylinder head with
screwdriver.
14. Remove sealing ring.
Installing injector
1. Remove all covers before installation.
2. Clean sealing surface on cylinder head and
protective sleeve.
3. Coat sealing ring with grease and insert in
groove of sealing cap.
4. Insert sealing cap in bore.
MS15018/03E 2016-02 | Injection Valve / Injector | 91
TIM-ID: 0000000023 - 005
To Next Page
Loading...
