356 – AL Open Load Cylinder B6
Yellow alarm; warning
Cause Corrective action
Open circuit in cylinder B6
injector wiring. Result: Misfiring.
1. Check injector wiring, exclude disruption in solenoid valve (e.g. by
injector replacement).
2. Fault is rectified after each working cycle.
357 – AL Open Load Cylinder B7
Yellow alarm; warning
Cause Corrective action
Open circuit in cylinder B7
injector wiring. Result: Misfiring.
1. Check injector wiring, exclude disruption in solenoid valve (e.g. by
injector replacement).
2. Fault is rectified after each working cycle.
358 – AL Open Load Cylinder B8
Yellow alarm; warning
Cause Corrective action
Open circuit in cylinder B8
injector wiring. Result: Misfiring.
1. Check injector wiring, exclude disruption in solenoid valve (e.g. by
injector replacement).
2. Fault is rectified after each working cycle.
359 – AL Open Load Cylinder B9
Yellow alarm; warning
Cause Corrective action
Open circuit in cylinder B9
injector wiring. Result: Misfiring.
1. Check injector wiring, exclude disruption in solenoid valve (e.g. by
injector replacement).
2. Fault is rectified after each working cycle.
361 – AL Injector Power Stage Low
Yellow alarm; warning
Cause Corrective action
Internal electronic fault,
electronics possibly faulty.
1. Start Engine Control Unit self-test.
2. Replace ECU in case of fault; if self-test diagnoses “Electronics OK”
check for additional fault messages (e.g. wiring fault).
362 – AL Injector Power Stage High
Yellow alarm; warning
Cause Corrective action
Internal electronic fault,
electronics possibly faulty.
1. Start Engine Control Unit self-test.
2. Replace ECU in case of fault; if self-test diagnoses “Electronics OK”
check for additional fault messages (e.g. wiring fault).
MS150094/02E 2015-05 | Troubleshooting | 63
TIM-ID: 0000060724 - 001
To Next Page
