6.2 Fault messages on the SAM display (optional)
The fault code numbers are generated by the engine governor and transmitted to the following display:
The fault code (1) comprises three digits.
Fault messages can also be caused by faulty sensors/actuators. If the fault cannot be corrected with
the troubleshooting information provided in the following table, contact Service. Our Service will check
sensors/actuators and replace them if necessary.
The following fault codes may appear on the display: (→ Page 38).
MS150112/01E 2014-10 | Troubleshooting | 37
TIM-ID: 0000029308 - 003
To Next Page