Power control
Use this control mode when operating
the mounted machines (ploughs and cul-
tivators). Move the power control handle
(1) to foremost position in the direction of
the tractor motion (digit “9” on the board).
• Move the lower rod joints to the required
position using the position control handle
(2) and attach the implement to the rear
hitch.
• Having entered the furrow, push the
handle (2) to foremost position and ad-
just the required tillage depth using the
handle (1).
• When leaving and leaving subsequently
the furrow (when tilling), use the handle
(2) only without touching the power con-
trol handle (1).
Combined control
If you cannot reach steady soil tilling depth
due to non-uniform soil density, limit the
maximum depth by the position control
handle (2) (combined control mode), hav-
ing remembered the respective digit on
the board.
To Next Page
Loading...
