Stopping the tractor
To stop the tractor:
• Reduce the engine crankshaft speed;
• Step on the clutch pedal;
• Set the change gear lever to neutral
position;
• Stop the tractor by applying the ser-
vice brakes;
• Apply the parking brake.
Steering control
IMPORTANT! The tractors are
equipped with the hydrostatic power
steering system. If the engine is
stopped, the pump does not supply the
system and it begins automatically op-
erating in the manual mode where turn-
ing the tractor requires applying more
force to be applied to the steering
wheel.
IMPORTANT! To stop the tractor in
case of emergency, step on the clutch
pedal and twinned service brakes pe-
dal at the same time.
Shutting down the engine
IMPORTANT! Prior to shutting down
the engine, lower the implement onto
the ground and let the engine operate
at 1000 rpm within 1…2 min. This will
decrease engine temperature.
To shut down the engine, proceed as fol-
lows:
• set manual fuel feed arm to minimal feed
position (back to the stop);
• disengage the PTO and set all the dis-
tributor’s levers to neutral position;
• lower the implement onto the ground;
• pull engine shut-off lever cord handle to
fully stop the engine;
• turn ground switch off to avoid storage
battery run-down.
To Next Page
Loading...
