any obstacle.
• When moving with attached
mechanisms or implements, always
apply a mechanism to lock on the
attachment in lifted position.
• The drive shaft transferring the ro-
tation from the tractor PTO to the
driven components shall be en-
closed.
• Make sure that any additional
equipment or auxiliaries are in-
stalled correctly and that they are
designed for application with your
tractor. Keep in mind that your trac-
tor, if used unduly can be danger-
ous both for yourself and other per-
sons. Do not operate equipment
not designed for installation on the
tractor.
• To avoid turnover, be careful
when driving the tractor. Choose
safe speed corresponding to road
conditions, particularly when driving
cross-country, passing the ditches,
slopes and during sharp turns.
• When operating on the slopes, in-
crease the tractor track to the max-
imum value.
• Do not make sharp turns under
full load and high speed.
• When using the tractor for trans-
portation works:
- increase the tractor track to at
least 1800 mm;
- interlock the brake pedals, check
and, if necessary, adjust the brakes
to synchronous action;
- check operation of the parking
brake, brake pneumatic drive and
trailer brakes;
- check the state of the light and
audio alarm devices;
- transport trailers shall be fitted
with rigid hitches and connected by
means of the safety chain or rope;
- never drive downhill with
switched-off gear (coasting), apply
the same gear both down and up-
hill;
- it is forbidden to work with the
trailer without independent brakes,
if its weight exceed half actual
weight of the tractor. The faster you
move and the larger the towed
mass is, the larger the safety dis-
tance shall be;
- disengage the FDA to avoid ex-
cessive wear and tear of the drive
parts and tires;
- do not use rear axle differential
lock (DL) at the speed of above 10
km/h and during turns;
Important! Use the synchronous
PTO drive at the lower gears of the
gearbox at the tractor movement
speed not exceeding 8 km/h. Other-
wise, the tractor’s power train can be
severely damaged.
- do not stop the tractor on the
slopes. If the stop is still necessary,
engage the 1
st
gear and apply the
parking brake.
• when operating the equipment
driven by PTO, make sure that the
PTO coupler shank has fully
stopped after stopping the engine
before leaving the cab and discon-
necting the equipment.
• Do not wear loose clothes when
operating PTO or near the rotating
equipment.
• When operating stationary mech-
anisms driven by PTO, always ap-
ply the parking brake and lock on
the rear wheels from the front and
behind. Make sure that the mecha-
nism has been reliably secured.
• Make sure that the PTO coupler
shank protection has been installed
and, if the PTO is not used, refit the
cap of the PTO coupler shank.
To Next Page
Loading...
