EasyManua.ls Logo

MTZ 952 - Tractor Storage

Default Icon
269 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MTZ 1221/1221В/1221.2/1221В.2/1221.3/1221В.3 Section Х. Storage of the tractor
Х228
228
STORAGE OF THE TRACTOR
Prior to putting the tractor for a long-term
storage, perform the following operations:
Clean the tractor.
Clean the tractor inside and outside.
Gun-grease all the lube points, namely.
Drain oil from the engine crankcase,
power train, tank of the hydraulic sys-
tem and HPS, wheel reduction gears
and final drive of the FDA and refill
them with fresh clean oil.
Drain fuel from the fuel tanks and pour
about 5 l of preservation fuel.
Start the engine and let it run for 5...10
minutes until the feeding system is
filled.
Lift the RHM rods to the top position
and engage the fixing mechanism
(RHM with an autonomous power cyl-
inder).
Remove the storage batteries, charge
them and put for storage in a dry venti-
lated room with the temperature of
15..20°С. Check the condition of the
batteries every month and recharge
them as necessary.
Lift the front and rear axles of the trac-
tor by means of jacks and put the trac-
tor onto the stands for unloading the
tyres. Reduce the pressure in the tyres
down to 70% of the normal value.
Drain the cooling fluid from the engine
cooling system and the cab-heating
one.
Preserve the plunger of the hydraulic
steering cylinder or turn the front
wheels in such a way that the rod
would be in the retracted position.
Loosen the tension of the generator
and fan belts.
Put a jacket on the exhaust pipe hole.
Crank the engine crankshaft to several
revolutions at least once a month.
To remove the tractor from the long-term
storage, perform the following operations:
Remove the tractor from stands and
bring the pressure in tyres to its normal
value.
Fill up fuel tanks.
Check the level of cooling fluid and oil
in all the vessels to be filled.
Re-install fully charged storage batter-
ies
Remove the jacket from the exhaust
pipe.
Start the engine and carry out the func-
tional checks on all the tractor instru-
ments, controls and systems.
Check the operation of the lighting and
audible signalling devices.
Run the tractor without load to make
sure that it operates properly.
IMPORTANT! The operations for putting
the tractor for storage and removing
the same from the storage in the part
related to the engine shall be per-
formed according to the operating
manuals provided by the engine manu-
facturer.

Other manuals for MTZ 952

Related product manuals