The tractor motion with the synchronous
PTO drive engaged is allowed at the
speed of not more than 8 km/h;
f ) Disengage the PTO when turning the
unit (for trailed machines), as well as
when lifting the machine to the
transport position (for mounted and
semi-mounted machines);
g ) Having unhooked the machine from
the tractor do not leave the driveline
joint on the PTO shank;
h ) When installing the driving pulley on
the rear PTO cover, as well as reduc-
ing gear for driving a special machine
(cotton-growing, excavating machines,
etc.), make sure that they are centred
relatively the shank (seated into bor-
ing Ø162 mm on the rear cover) and
their fixing nuts are reliably tightened.
When working with rotary machines for
tillage:
a ) Watch the running order and normal
operation of safety devices;
b ) Do not engage PTO on when the driv-
en element is on the ground;
c ) Lower the machine with rotating oper-
ating parts smoothly during the tractor
motion;
d ) Do not engage PTO, if the refraction
angle at one of the driveline joints ex -
ceeds 35;
e ) When operating on hard soils, till lat-
eral strips to enter the field and only
after that carry out the tillage in longi-
tudinal direction.
Operating the trailers and trailed ma-
chines
The single-axle machines like semi-
trailers are hooked up to the tractor by
means of the ТСУ-2 and the trailed
ones – via ТСУ-ЗK*' (trailer gear with
automatic hitch). Transporting the ma-
chines by using ТСУ-1Ж (cross-bar) is
allowed at the speed of below 15 km/h
without entering general-purpose roads
and when performing the agricultural
works.
ATTENTION!
It is strictly forbidden to unitize the ma -
chines like trailers and semi-trailers via
ТСУ-1Ж (cross-bar) .
Connect the connecting heads of the
trailer pneumatic system with the tractor
pneumatic system depressurized.
When working with single-axle trailed
machined, install additional weights for
loading additionally the front axle of the
tractor.
Two-axle trailers are hooked up to the
tractor by means of the ТСУ-ЗК or ТСУ-
ЗВ (their hitching with the ТСУ-1Ж fork
is not allowed). Having hooked up the
tractor with the trailer, make sure that
the latch has fully left the body, and
connect the trailer to the tractor with
the safety chain (cord).
When trailer gear is installed on the tractor,
it is forbidden to attach semi-trailers (sin-
gle-axle trailers) as well as two-axle trailers
with non-standard hitch to it.
________________________________
Via ТСУ-2В or ТСУ-ЗВ – for tractors
equipped with hydraulic lift.
To Next Page
Loading...
