Need help?Do you have a question about the Multiplex EasyStar and is the answer not in the manual?
General| Material | Elapor |
|---|---|
| Control | Elevator, rudder, motor |
| Battery | 2S LiPo or NiMH |
| Radio | 4 channel |
| Flying weight | 680 g |
List of required remote control systems and receivers for the model.
Specifies compatible drive batteries (NiCd, NiMh) for the model.
Details the recommended charging unit for the model's batteries.
Recommendations for suitable glues, emphasizing cyanoacrylate.
Lists essential tools required for assembling the model kit.
Guidance on checking kit contents and preparation before starting construction.
Instructions for assembling the fuselage halves and installing the motor.
Steps for installing the locking mechanism for the model's canopy.
Procedure for attaching rudder horns and linkage connections to control surfaces.
Instructions for properly gluing the elevator and rudder components.
Detailed steps for attaching the elevator and rudder to the fuselage.
Guide on fitting the servo motors into the fuselage and routing cables.
Steps for installing the control linkages for the rudder and elevator.
Instructions for routing and securing the receiver antenna.
Procedure for gluing the canopy locking pins into place.
Guide on securely attaching the propeller to the motor shaft.
Instructions for properly inserting and securing the wings.
Ensuring correct attachment of wings to the fuselage after gluing.
Guidance on placing the flight battery and receiver for proper balance.
Setting the correct travel range for elevator and rudder control surfaces.
Instructions for applying decorative elements to the model.
Procedure for determining and adjusting the model's center of gravity.
Steps for preparing the model and radio system for the initial flight.
Advice and procedure for conducting the model's maiden flight.
General safety guidelines and recommendations for flying model aircraft.
Explanation of the airfoil's aerodynamic principle and lift generation.
Importance of correct CG and method for checking and adjusting it.
Description of control surfaces and recommended travel ranges for optimal flight.
Explanation of transmitter stick functions and their assignment to control surfaces.
To Next Page