14
Accessories and tools
Specications
List of parts
Required accessories Required tool
Optional accessories
Serial no.
Qty. Name Material
1 1 Left fuselage half Foamed ELAPOR
2 1 Right fuselage half Foamed ELAPOR
3 1 Left wing Foamed ELAPOR
4 1 Right wing Foamed ELAPOR
5 1 Left landing ap Foamed ELAPOR
6 1 Right landing ap Foamed ELAPOR
7 1 Tailplane Foamed ELAPOR
8 1 Vertical tail Foamed ELAPOR
9 1 Canopy Foamed ELAPOR
10 1 Spinner Foamed ELAPOR
Foam parts
Serial no.
Qty. Name Material
11 1 Motor mount Injected plastic
12 2 Wing counter bearing Injected plastic
13 1 Canopy hand-hold plate Injected plastic
14 1 Tailwheel hinge vertical tail Injected plastic
15 1 Tailwheel hinge fuselage Injected plastic
16 1 Front wingspar connector Injected plastic
Plastic parts
Wingspan 1410 mm
Overall length 1050 mm
Flight weight 1380 g
Wing area 39.9 dm²
Wing loading 34.6 g/dm²
RC functions Aileron, elevator, rudder, motor,
landing aps, optional aero-tow release
• 2 x Zacki2 ELAPOR
®
20g # 1-01291
• 1x Zackivator - activator for Zacki and CA adhesive # 1-01032
• 1 x power kit FunCub NG # 1-01423
• 4 x servo HS 55+ # 1-01205
• 2 x servo HS 65 HB # 112065
• 1 x cable set FunCub NG # 1-01478
• 1 x receiver RX-7-DR light M-LINK 2.4 GHz # 55810
• 1 x ROXXY EVO LiPo 3 - 2600M 40C with BID chip
# 316656
When using aero-tow release, we recommend:
• 1 x receiver RX-9-DR M-LINK 2.4 GHz
(instead of RX-7)
# 55812
• 1 x medium-sized slotted screwdriver
• 1 x small at nose pliers
• 1 x hex wrench 1.5 mm (included)
• 1 x 10 mm open-ended wrench or socket wrench
• 1 x sheet of 240-320 grit sandpaper
• 1 x cockpit SX telemetry set # 25161
• 1 x oat kit FunCub # 1-01539
• 1 x oat kit FunCub NG blue # 1-01585
• 1 x servo 55+ for aero-tow release # 1-01205
• 1 x POWER-MULTIlight # 73030
• 1 x LiPo checker # 118380
• 1 x Hitec multi charger X1 red # 114131
• 1 x Wingstabi 7 channel # 55010
• 1 x Wingstabi RX 7 DR # 55012
• 1 x propeller balancer # 332355
EN
To Next Page
Loading...
Need help?
General