EasyManua.ls Logo

Multiplex PARTENAVIA P.68 - Trouble Shooting; Aircraft Not Responding; Propeller Noise or Vibration; Reduced Flight Times or Power

Multiplex PARTENAVIA P.68
40 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
23
Trouble Shooting
Problem Possible Cause Solution
Aircraft not responding to the throttle but
responding to other controls
- ESC not calibrated
- throttle deactivated on radio
- motor wire disconnected
- Calibrate ESC according to manual
- activate throttle on radio
- check motor wires and connect/repair as
required
Excessive propeller noise or Excessive
vibration
- Propeller/EDF loose or damaged
- Propeller/EDF out of balance
- Propeller/EDF fan incorrectly installed or
mounting loose
- Tighten and/or Replace damaged parts
- balance propeller/EDF unit
- Remove and install the propeller correctly
-
ensure mounting tight and parts correctly tted
Reduced ight times or aircraft underpowered
- Low battery charge
- ESC overheating
- Defective battery
- Recharge battery
- Ensure adequate cooling to ESC
- Replace battery with new one
Control surface not moving, or responds
slowly to control inputs
- Control surface, control horn, linkage or
servo damaged
- Wire damaged or connector loose
- Replace or repair damaged parts and adjust
controls
- Check all wires and ensure connections are
secure
- Repair/replace damaged wires or connectors
Control surface reversed - Channels reversed on the transmitter
- Check transmitter settings and adjust as
required
Motor loosing power in ight
- ESC not calibrated correctly
- ESC LVC low voltage cutoff activated
- Defective motor, ESC, or battery
- Recalibrate ESC
- Check the battery, transmitter, receiver, ESC,
motor and replace it if defective
- Get the aircraft land immediately and
recharge the battery
Slow LED ash on the receiver - Receiver power loss
- Check the connection between ESC and
receiver
- Check if servo is damaged
- Check if the linkages are in place
EN

Related product manuals