Page 7
ABSOLUTE OUTBAND ALARM
RLY-ON
RLY-ON
RLY-ON
RLY-OFF
RLY-ON
RLY-OFF
RLY-OFF
RLY-OFF
RLY-OFF
SET
SET
HYST
HYST
ALARM OPERATION
HIGH ALARM:
INBAND ALARM
ABSOLUTE LOW ALARM
RLY-OFF
RLY-OFF
RLY-ON
RLY-ON
RLY-ON
RLY-ON
RLY-OFF
RLY-ON
RLY-ON
RLY-ON
RLY-ON
RLY-OFF
RLY-OFF
RLY-OFF
S.V
S.V
SET
HYST
HYST
HYST
R3-Alarms
1) Heater Break alarm: - If the current of the Heater < AMP SV
(unhealthy condition) then Relay turns ON and Upper
Display will show , middle display will blink showing . hbr h
To manually turn off Relay, press ENT key 4 sec. Display will
continue showing till the fault is rectified.hbr
2) Cold start (CS) alarm: Relay is initially OFF. When PV >
Alarm SV, Relay turns ON. When PV < Alarm SV MINUS
HYS, Relay turns OFF.
Specifications are subject to change, since development is a continuous process,
So for more updated operating information and Support,
Please contact our Helpline: 9081078683/9081078681 or
Email at Ver:191201service@multispanindia.com
To Previous Page
Loading...
