RPR 550IS Series
TM1188 Issue 1 Page 2 - 5
Table 1: Status Messages
Description Format Priority When Used
New message
x new
1 there are x message(s) with new
message(s)
status (x = 1 to 5)
Out-of-Range
out of range
2 option is enabled and no
in-range signal has been
received for 3.5 minutes
Low Battery
low battery
3 option is enabled and cell voltage
is below the trigger point
Time
12:00
3 option is enabled and the pager
is not out of range
Mute
mute
3 pager is in Mute mode
On
on
3 no other status messages to
display
Receiving a Paging Call
9. There are eight different audible tone alert patterns (beep codes) plus one silent alert.
When the pager receives a call using one of the eight beep codes the user is alerted
(where applicable) by:
a) The audible tone alert pattern (except in Mute mode).
b) The alert LED flashing in unison with the tone alert pattern.
c) The display message (refer to Figure 3).
d) Pager vibration, if fitted.
e) Speech.
10. The silent alert causes the pager to react as if it were in the Mute mode.
To Next Page
Loading...
