Maintenance
Change the oil in the vacuum pump
74 10.06.2014
¾ Fill the vacuum pump with oil up to the middle of the oil sight
glass. Use only oils that are approved by the manufacturer, see
'Spare Parts' section or the spare parts list.
Info
Only use low odour synthetic oil if foodstuffs are being packed.
max.
min.
¾ Check oil level on the oil sight glass:
– The oil level should reach the middle of the oil sight glass.
– If oil level is under the MIN mark, add oil.
¾ Replace the sealing ring in the screw plug.
¾ Insert the screw plug with the sealing ring in the fill opening and
screw it tight.
¾ Fasten the safety guard with the screws.
¾ Connect the machine to the mains electricity.
¾ Switch on the machine.
¾ Check the oil level after a couple of machine cycles.
To Next Page
Loading...
