multivac C250 - Machine Cleaning Steps (Daily and Intensive)

Cleaning
Cleaning the machine
58 10.06.2014
6.2 Cleaning the machine
Info
• The recommended daily cleaning tasks recommended here must
be supplemented by the intensive cleaning procedure according
to the degree of dirt.
• Cleaning personnel must be instructed for the cleaning work by
the operating company.
• The sequence of the described tasks is to be followed exactly.
6.2.1 Performing daily cleaning
Info
• The intensive cleaning may only be performed by specially
trained personnel.
• The sequence of the described tasks is to be followed exactly.
• In the following, optional equipment versions are also described.
Only perform steps that correspond to the version of the ma-
chine.
• Always clean the machine from top to bottom.
• For all cleaning work, follow the safety instructions, see Section
6.1 "N
OTES ON CLEANING".
• The illustrations are examples.
Preparing for cleaning
¾ Remove all products from the machine.
¾ Switch off the machine.
¾ Disconnect the machine from the mains electricity.
¾ Cover the mains plug with waterproof plastic bags.
¾ Close the stop valve for the gas supply, if part of the machine.
¾ Allow the machine and sealing bars to cool down.
¾ Store empty, new film pouches outside the room in a clean, dry
place during the cleaning procedure.
¾ Remove all waste (e.g. product scraps, film trim) on or around the
machine.