5
Support: +1 650 206 2250
6
Support: +1 650 206 2250
4.0. Operating Instructions
4.1. Start-up
Turn on the power switch after connecting the machine to power supply,
the machine will spin the banknote processing wheel several times to
conduct a self-check, when the buzzer sounded twice, it means that the
self-test is passed.
Banknotes need to be put orderly and placed in the hopper as shown
in the following.
4.2. Banknotes Placement
4.3. Operating Modes
1) Place the bills neatly.
Figure 4-1 Banknote Placement Steps 1
3) Flip the bills in the direction as shown in Figure 4-3.
Figure 4-3 Banknote Placement Steps 3
4)The bills will automatically slide into the hopper after flipping.
The default mode is the Auto mode. By long pressing the “RESTART” button
to switch the counting between Auto and Manual. "YES" means automatic
counting mode, "NO" means manual counting mode.
In Auto mode, the IMC51 starts counting automatically as soon as the bills
are placed in the hopper.
In Manual mode, the IMC51 will not start counting automatically; you must
press the “RESTART” button to begin each count.
Figure 4-4 Banknote Placement Steps 4
2) Put the bills to the hopper as shown in Figure 4-2.
Figure 4-2 Banknote Placement Steps 2
4.3.1. Auto/Manual Mode
To Next Page
Loading...
