Munters MX2 60 - 3.6 Site requirements

3.4 Scopeofdelivery–steamreactivationsystem
The following steam components are included with the delivery:
Component MX²30 MX²35 MX²40 MX²55 MX²60 MX²80 MX²95
Steamvalve,
(Sauter)
VUG015F324 VUG015F324 VUG015F324 VUG015F324 VUG015F314 VUG015F304 VUG015F314
Actuator(Sauter) AVM234SF132
Steam batteryscrewflange
s(supplied loose): Carbonsteel,PN16,DIN2566, hubbed threaded.
The steamvalve is deliveredwithout companionflange (DN15)
Data sh eets for the v
alve and actuator are delivered with the components. Contact Munters for additional
information.
3.5 Storingthedehumidifier
Follow these instructions if the dehumidifier is to be stored prior to installation:
■ Place the dehumidifier in an upright position on a horizontal surface.
■ Re-use the packaging material to provide protection for the unit.
■ Protect the dehumidifier from physical damage.
■ Store the dehumidifier under cover and protect it from dust, frost, rain and agg r essive contaminants.
See section 8.4, Technical data for cor rect storage temperature.
3.6 Site requirements
NOTE! Itisimportantthattheintendedinstallationsitemeetstherequirementsinordertoachievethebest
possible performanceandtrouble-free operation.
NOTE! Itis importantforbothmaintenanceandservice purposesthatthe minimum servicespacerequirements
arecompliedwith.
Thedehumidifier is only intended for indoor installation. Avoid installing the dehumidifier in a damp
environment where there is a risk of water entering the unit, or in a very dusty environment. Refer to
Munters for advice if in doubt.
NOTE!
Ifthereisaneedforreduction ofvibrations fromthedehumidifier, contactMunters forinstructions. Refer
tostandardEN1299+A1:2008.
See section 8.3, Dimensions a nd service sp ace for unit and service dimensions.
18 Installation 190TEN–1089–G1412