Section 78 00-02-0859
2016-06-30 -16-
9. Allow the display to automatically reboot when you see the Check Mark Screen
momentarily.
10. You have successfully uploaded the new update file when you see the Murphy screen
momentarily display.
11. Power-Off the display and remove the components:
a. If applicable, remove the Programming Cable and the USB thumb drive.
b. If applicable, remove the SD card, ensure the seal is in the grove, install the
cover and secure it with the screws previously removed. Do not over tighten.
c. If applicable, reconnect any other components you may have removed.
d. Power-on the display when ready for use.
To Next Page
Loading...
Need help?
General
