Mustek POWERMUST 1590 User Manual

Line Interactive UPS
PowerMust 636 (650VA), Line Int.,IEC
PowerMust 848 (850VA), Line Int., IEC
PowerMust 424EG (450VA), Line Int., Schuko
PowerMust 636EG (650VA), Line Int.,Schuko
PowerMust 848EG (850VA), Line Int.,Schuko
PowerMust 1260(1200VA), Line Int., IEC/Schuko
PowerMust 1590(1500VA), Line Int., IEC/Schuko
PowerMust 2212(2200VA), Line Int., IEC/Schuko
Quick Start Guide
EN

Mustek POWERMUST 1590 Specifications

General

Capacity	1500 VA / 900 W
Input Voltage	220/230/240 VAC
Output Voltage	220/230/240 VAC
Waveform	Simulated Sine Wave
Battery Type	12V / 9Ah x 2
Operating Temperature	0°C to 40°C
Transfer Time	2-6 ms typical
Typical Recharge Time	4-6 hours
Communication	USB
Weight	11.5 kg
Output Frequency	50/60Hz ± 3Hz
Number of Outlets	4

Summary

Warranty and Service Information

Installing the Software

Instructions for installing UPS software from CD or download site.

Warranty Terms

Manufacturer's minimum one-year warranty, with terms varying by country/region.

Problem Solving Guidance

Advice to check the manual and website FAQ for troubleshooting.

Service and Maintenance Procedures

Contact reseller for service/maintenance during or after warranty.

Important Safety Instructions

General Safety Precautions

Covers essential safety warnings for UPS installation and use, including electrical hazards and environmental considerations.

Introduction to PowerMust UPS

Product Overview

Details the intelligent, compact line interactive UPS for PC protection against power interference.

Key Features

Highlights microprocessor control, AVR, DC Cold start, auto-restart, overload protection, and line protection.

Package Contents and Product Overview

Package Contents List

Lists items included in the package for different UPS models.

Product Front and Back Panel

Illustrates front panel LEDs and controls, and back panel outlets and connectors.

Installation and Startup Procedures

Placement and Storage Conditions

Specifies ideal protected environments, airflow, and spacing for UPS installation.

Connecting to Utility and Charging

Instructions for connecting the UPS to a grounded outlet and initial battery charging.

Connecting Loads to UPS

Guidance on plugging devices into UPS output receptacles.

Surge Protection for LAN/Modem/Phone

Steps to connect phone or modem lines for surge protection via the UPS.

Connecting USB Cable for Monitoring

Instructions for connecting the UPS to a PC via USB for status monitoring.

Turning the Unit On and Off

Procedure for powering the UPS unit on and off using the power switch.

Audible Alarms and Troubleshooting

Audible Alarm Indicators

Describes different alarm sounds and their corresponding situations (Battery Mode, Low Battery, Overload, Faulty).

Troubleshooting Common Issues

Provides solutions for common UPS problems like no LED display, continuous alarms, and short backup time.

Software Installation and Specifications

PC Software Installation

Guide to installing WinPower software for UPS monitoring and management.

UPS Technical Specifications

Detailed specifications including capacity, voltage, frequency, protection, environment, and physical dimensions.