-2-CS3007-03
Important!
During cleaning, please note the followings:
• Always follow this steps to perform daily maintenance.
When moistening the surface of nozzles, do not use the cleaning stick already used to clean the print head
circumference, cleaning wiper or cap circumference. Doing so may result in damage to the print head.
• Always use a new cleaning stick and dampen it with dedicated maintenance cleaner.
DO NOT use non-dedicated maintenance cleaner. It may cause nozzle clogging.
• Do not touch the tip of a cleaning stick with ngers. If sebum is adhered, it can cause damage to the print head.
• Do not reuse a cleaning stick. Dusts can adhere causing damage to the print head.
1. Cleaning of UV Lamp
1
2
3
Important!
Scraper
ÚDo not place any object inside the printer.
Open the front cover slowly, holding it by the
places shown in the picture and using both
hands.
Fully open the front cover.
Look in the stainless tray to check for ink or dust on the UV lamp.
Using a paper towel, remove ink and dust from the UV lamp.
*If ink deposits cannot be removed with the paper towel, use the scraper supplied with the
printer.
Press the scraper on the ink deposits with a slight angle and scrape o the ink deposits.
Use the paper towel to clean the ink scraped from the lamp.
• Make sure to use the scraper supplied with the printer.
• Never use the corner of the scraper. It can damage the UV lamp.
• When using the scraper, do not apply too much pressure to the lamp. It can damage the UV lamp.
2. Moistening the surface of print head nozzles
1
Put a cleaning stick in the plastic cup.
Use the dropper to dampen the swab of
cleaning stick with dedicated maintenance
cleaner.
(Amount used: 0.5 ml)
2
Lightly touch with the cleaning stick to moisten the nozzle surface.
Repeat it a couple of times to moisten the entire nozzle surface.
Look at the bottom side of the carriage.
Using the cleaning stick dampened with the maintenance cleaner, moisten the surface of the
print head nozzles.
Ú
DO NOT rub into the nozzle surface. It can cause damage to the print head.
ÚIf the entire nozzle surface has been moistened,you can stop it.
4
Next clean the print head circumference.
To Next Page
Loading...
Need help?
General