25
10. TROUBLESHOOTING
Troubleshooting
Problem Cause Solution
Motor does not start No fuel in the tank.
Fuel valve closed.
Motor oil level too low (oil warning lamp
is ickering).
On/O switch for motor operation in
wrong position
Dirty ignition plug.
Dirty air lter.
Fill the tank with fresh fuel.
Turn the fuel valve to „ON“.
Rell motor oil.
Switch to the right position.
Clean/replace the ignition
plug.
Clean/replace the air lter.
Motor is noisy and irregular. Dirty ignition plug.
Dirty air lter.
Fuel contaminated/old
Choke switched to „CHOKE“ Wrong fuel,
e.g. diesel instead of petrol.
Clean/replace the ignition
plug.
Clean/replace the air lter.
Replace the fuel.
Turn choke switch to “RUN“
Replace the fuel with the
correct one.
No electrical output. Overload protection switch in the AC
power generator released.
Reactivate the protection
switch.
Contact a service centre
responsible for warranty
cases.
Motor does not stop. Ignition switch-o wire damaged. Close the fuel valve and
wait for the motor to switch
o.
11. REPAIR
Only use accessory and replacement parts
recommended by the manufacturer. If the
appliance should fail in spite of our quality control
and your care, have it repaired by an authorized
technician only.
12. ENVIRONMENTAL PROTECTION
Do not simply dispose of the appliance, its
accessories and packaging into the household
waste, but recycle it instead. This small eort helps
our environment.
To Next Page
Loading...